Vista Imaging Routing Manual de usuario descargar pdf (Pagina 60)

Using the Routing Gateway Routing User Guide

5 Position and size the terminal window for subsequent monitoring. (Note that no new

information will be shown in the terminal window until the evaluation processor

encounters entries in the rule evaluation queue.)

Starting the Transmission Processor

1 Open a new terminal window and log into the DICOM Gateway software.

2 Enter 3 to select “Routing Gateway” from the DICOM Gateway Menu [MAGDMENU].

3 Enter 1 to select “Start the Transmission Processor.”

4 A list of destinations will be displayed. To select all possible destinations, enter an

asterisk (*). To enter a partial list, follow the instructions at the prompt.

Possible destinations are:

125: KANSAS at \\TELERAD3\wichita

152: ST LOUIS CR at \\vhastlvistarad

164: IMAGPROVIDER1 at C:\REMOTE\IMAG1\

166: LEAVENWORTH, KS at C:\REMOTE\LVW\

167: IMAGPROVIDER2 HOME at C:\REMOTE\IMAG2\

168: ST. LOUIS, MO at C:\REMOTE\STL\

Select destinations by:

==> Enter their number(s), separated by commas

==> Enter an asterisk (*) to select all possible destinations

Prefixing an entry with a dash deselects the listed

destinations

Enter a period when the selection is complete.

---> *

5 The destinations you selected will be displayed. Enter a period when you are finished.

6 Position and size the terminal window for subsequent monitoring.

As the transmission processor sends exams to Imaging destinations, it will map

and un-map certain drives. For more information, see page

66.

7 To start additional transmission processors, repeat steps 1 – 6 in a new terminal

window.

VistA Imaging V. 3.0, Patch 18 April 2006 52

1 2 ... 55 56 57 58 59 60 61 62 63 64 65 ... 96 97

Sin comentarios

Vista Imaging Routing Manual de usuario Pagina 60